Linux version 2.6.11 (root@Knoppix) (gcc-Version 3.3.5 (Debian 1:3.3.5-12)) #3 SMP Mon May 2 00:19:56 CEST 2005 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000000fef0000 (usable) BIOS-e820: 000000000fef0000 - 000000000fef3000 (ACPI NVS) BIOS-e820: 000000000fef3000 - 000000000ff00000 (ACPI data) BIOS-e820: 00000000ffb00000 - 0000000100000000 (reserved) 0MB HIGHMEM available. 254MB LOWMEM available. On node 0 totalpages: 65264 DMA zone: 4096 pages, LIFO batch:1 Normal zone: 61168 pages, LIFO batch:14 HighMem zone: 0 pages, LIFO batch:1 DMI 2.1 present. ACPI: RSDP (v000 GBT ) @ 0x000f65c0 ACPI: RSDT (v001 GBT AWRDACPI 0x00000000 0x00000000) @ 0x0fef3000 ACPI: FADT (v001 GBT AWRDACPI 0x00000000 0x00000000) @ 0x0fef3040 ACPI: DSDT (v001 GBT AWRDACPI 0x00001000 MSFT 0x0100000a) @ 0x00000000 ACPI: BIOS age (1999) fails cutoff (2002), acpi=force is required to enable ACPI ACPI: Disabling ACPI support Allocating PCI resources starting at 0ff00000 (gap: 0ff00000:efc00000) Built 1 zonelists Kernel command line: ramdisk_size=100000 init=/etc/init lang=us apm=power-off vga=791 initrd=minirt.gz nomce quiet BOOT_IMAGE=knoppix BOOT_IMAGE=linux __iounmap: bad address c00fffd9 Local APIC disabled by BIOS -- you can enable it with "lapic" mapped APIC to ffffd000 (01300000) Initializing CPU#0 PID hash table entries: 1024 (order: 10, 16384 bytes) Detected 601.562 MHz processor. Using tsc for high-res timesource Console: colour VGA+ 80x25 Dentry cache hash table entries: 32768 (order: 5, 131072 bytes) Inode-cache hash table entries: 16384 (order: 4, 65536 bytes) Memory: 252736k/261056k available (1846k kernel code, 7740k reserved, 943k data, 292k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay loop... 1183.74 BogoMIPS (lpj=591872) Security Framework v1.0.0 initialized SELinux: Disabled at boot. Mount-cache hash table entries: 512 (order: 0, 4096 bytes) CPU: After generic identify, caps: 0383f9ff 00000000 00000000 00000000 00000000 00000000 00000000 CPU: After vendor identify, caps: 0383f9ff 00000000 00000000 00000000 00000000 00000000 00000000 CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 512K CPU: After all inits, caps: 0383f9ff 00000000 00000000 00000040 00000000 00000000 00000000 Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Checking 'hlt' instruction... OK. Checking for popad bug... OK. CPU0: Intel Pentium III (Katmai) stepping 03 per-CPU timeslice cutoff: 1463.06 usecs. task migration cache decay timeout: 2 msecs. SMP motherboard not detected. Local APIC not detected. Using dummy APIC emulation. Brought up 1 CPUs CPU0 attaching sched-domain: domain 0: span 00000001 groups: 00000001 checking if image is initramfs...it isn't (no cpio magic); looks like an initrd Freeing initrd memory: 1082k freed NET: Registered protocol family 16 EISA bus registered PCI: PCI BIOS revision 2.10 entry at 0xfb180, last bus=1 PCI: Using configuration type 1 mtrr: v2.0 (20020519) ACPI: Subsystem revision 20050211 ACPI: Interpreter disabled. Linux Plug and Play Support v0.97 (c) Adam Belay pnp: PnP ACPI: disabled PnPBIOS: Scanning system for PnP BIOS support... PnPBIOS: Found PnP BIOS installation structure at 0xc00fbb00 PnPBIOS: PnP BIOS version 1.0, entry 0xf0000:0xbb30, dseg 0xf0000 PnPBIOS: 18 nodes reported by PnP BIOS; 18 recorded by driver SCSI subsystem initialized PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) PCI: Transparent bridge - 0000:00:1e.0 PCI: Using IRQ router PIIX/ICH [8086/2410] at 0000:00:1f.0 audit: initializing netlink socket (disabled) audit(1149082329.755:0): initialized Total HugeTLB memory allocated, 0 VFS: Disk quotas dquot_6.5.1 Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) Initializing Cryptographic API isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found serio: i8042 AUX port at 0x60,0x64 irq 12 serio: i8042 KBD port at 0x60,0x64 irq 1 io scheduler noop registered io scheduler anticipatory registered io scheduler deadline registered io scheduler cfq registered Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 RAMDISK driver initialized: 16 RAM disks of 100000K size 1024 blocksize Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ICH: IDE controller at PCI slot 0000:00:1f.1 ICH: chipset revision 2 ICH: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:DMA, hdd:DMA Probing IDE interface ide0... hda: ST38410A, ATA DISK drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 Probing IDE interface ide1... hdc: MATSHITADVD-ROM SR-8584A, ATAPI CD/DVD-ROM drive hdd: CD-W54E, ATAPI CD/DVD-ROM drive ide1 at 0x170-0x177,0x376 on irq 15 Probing IDE interface ide2... Probing IDE interface ide3... Probing IDE interface ide4... Probing IDE interface ide5... hda: max request size: 128KiB hda: 16841664 sectors (8622 MB) w/512KiB Cache, CHS=16708/16/63 hda: cache flushes not supported hda: hda1 hda2 < hda5 > hdc: ATAPI 32X DVD-ROM drive, 512kB Cache Uniform CD-ROM driver Revision: 3.20 hdd: ATAPI 32X CD-ROM CD-R/RW drive, 1280kB Cache libata version 1.10 loaded. mice: PS/2 mouse device common for all mice input: AT Translated Set 2 keyboard on isa0060/serio0 input: ImPS/2 Logitech Wheel Mouse on isa0060/serio1 EISA: Probing bus 0 at eisa0 Cannot allocate resource for EISA slot 4 EISA: Detected 0 cards. NET: Registered protocol family 2 IP: routing cache hash table of 1024 buckets, 16Kbytes TCP established hash table entries: 8192 (order: 5, 131072 bytes) TCP bind hash table entries: 8192 (order: 4, 98304 bytes) TCP: Hash tables configured (established 8192 bind 8192) NET: Registered protocol family 1 NET: Registered protocol family 15 RAMDISK: Compressed image found at block 0 EXT2-fs warning: checktime reached, running e2fsck is recommended VFS: Mounted root (ext2 filesystem). seagate: ST0x/TMC-8xx not detected. Failed initialization of WD-7000 SCSI card! usbcore: registered new driver usbfs usbcore: registered new driver hub USB Universal Host Controller Interface driver v2.2 PCI: Found IRQ 10 for device 0000:00:1f.2 uhci_hcd 0000:00:1f.2: Intel Corp. 82801AA USB PCI: Setting latency timer of device 0000:00:1f.2 to 64 uhci_hcd 0000:00:1f.2: irq 10, io base 0xd000 uhci_hcd 0000:00:1f.2: new USB bus registered, assigned bus number 1 hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected ohci_hcd: 2004 Nov 08 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI) ub: sizeof ub_scsi_cmd 64 ub_dev 2504 usbcore: registered new driver ub Initializing USB Mass Storage driver... usbcore: registered new driver usb-storage USB Mass Storage support registered. ieee1394: Initialized config rom entry `ip1394' sbp2: $Rev: 1219 $ Ben Collins ieee1394: sbp2: Driver forced to serialize I/O (serialize_io = 1) Unable to identify CD-ROM format. VFS: Can't find an ext2 filesystem on dev hda. FAT: invalid media value (0x00) VFS: Can't find a valid FAT filesystem on dev hda. cdrom: open failed. cdrom: open failed. cdrom: open failed. ISO 9660 Extensions: Microsoft Joliet Level 3 ISO 9660 Extensions: RRIP_1991A cloop: Initializing cloop v2.02 cloop: loaded (max 8 devices) cloop: /cdrom/KNOPPIX/KNOPPIX: 30413 blocks, 65536 bytes/block, largest block is 65552 bytes. ISO 9660 Extensions: RRIP_1991A Registering unionfs version $Id: main.c,v 1.85 2005/03/14 22:19:49 dquigley Exp $ Freeing unused kernel memory: 292k freed Real Time Clock Driver v1.12 apm: BIOS version 1.2 Flags 0x07 (Driver version 1.16ac) Linux Kernel Card Services options: [pci] [cardbus] [pm] usbcore: registered new driver hiddev usbcore: registered new driver usbhid drivers/usb/input/hid-core.c: v2.0:USB HID core driver Serial: 8250/16550 driver $Revision: 1.90 $ 14 ports, IRQ sharing disabled ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A parport: PnPBIOS parport detected. parport0: PC-style at 0x378 (0x778), irq 7, dma 3 [PCSPP,TRISTATE,COMPAT,ECP,DMA] ne2k-pci.c:v1.03 9/22/2003 D. Becker/P. Gortmaker http://www.scyld.com/network/ne2k-pci.html eth0: RealTek RTL-8029 found at 0xb800, IRQ 11, 00:50:BA:A7:E0:E7. ymfpci: YMF744 at 0xe4000000 IRQ 10 ac97_codec: AC97 Audio codec, id: 0x8384:0x7609 (SigmaTel STAC9721/23) NET: Registered protocol family 17 Linux agpgart interface v0.100 (c) Dave Jones [drm] Initialized drm 1.0.0 20040925 PCI: Found IRQ 11 for device 0000:00:01.0 [drm:drm_fill_in_dev] *ERROR* Cannot initialize the agpgart module. DRM: Fill_in_dev failed. eof